How To Change Headlight On 2011 Chevy Malibu

Replacing the headlight bulbs on your Chevy Malibu can be a little tricky. You will have to at least partially remove the front bumper to get to the headlight assembly and proceeds admission to the headlight bulbs. While it isn't the almost difficult car to change headlight bulbs on, it can be i of the more time consuming. Follow these instructions to make the process go a little easier.

NOTE: Here'southward a slap-up video on the headlight removal process that will make irresolute the bulb that much easier.

Step 1:

First, remove the xi 10mm bolts and iv plastic pop rivets which are property the radiator embrace down.

Pace ii:

Later you remove the bolts and plastic rivets, lift off the radiator cover and set it bated.

Step iii:

Turn the steering bike all the way in the opposite direction of the burnt out seedling to make enough room in the wheel well area. Some people may find it easier to just remove the vehicle's front cycle birthday for more work infinite.

Pace 4:

Going underneath the front bumper, y'all'll demand to locate the 7mm bolts on the plastic underbody cover and remove them. There'southward also one plastic rivet on each side that will need to exist removed.

Step 5:

Next, remove the pop rivets that hold the cycle well liner in place and pull back the liner to access the ii 10mm bolts holding the bumper encompass in place. The closest bolt to yous will need to exist removed, while the one closer to the outside of vehicle simply needs to be loosened.

Pace six:

Now that you're at the headlight assembly, you'll detect that it'southward held in place by 4 10mm bolts. Remove these bolts and pull off the subclass to a higher place the headlight.

Step seven:

The headlight assembly volition finally be complimentary from the vehicle and the bulb is at present attainable. To tell the headlight bulb apart from the high beam — the high beam has a light blue plastic label. To remove the bulbs, grab the base and rotate 1/4 turn counter clockwise to unlock it and pull information technology direct out.

Step 8:

Pull the bulb from the power connector, you may have to use a flathead screwdriver to get it out.

Step 9:

Install a new bulb and button the base back into the headlight assembly.

Footstep x:

From here, it'southward a affair of reversing these steps and putting everything back into place.

*Annotation, while you lot may have noticed that one specific bulb is burnt out, it might not hurt to audit the rest while you lot're in there for signs of harm. It might even be worth it to change all of the bulbs while you're in there to keep from having to redo this process in a week because y'all replaced a low beam and non a high beam.

Source: https://www.newgmparts.com/how-to-replace-headlight-bulbs-on-your-2008-2012-chevy-malibu

Posted by: quinnoloplath.blogspot.com

Share this post